Hargrove Gas Logs

Table Of Contents

American Chimney Sweeps

Providing Quality Products And Accessories For Fireplaces

Hargrove Gas Logs

Propane Conversion Kit Installation (For Use With Propane Gas)

If you have purchased a gas log set for Natural Gas but you will be burning it with Propane Gas, please follow these conversion instructions for proper conversion and operation.

General Information

Do not use a natural gas set for propane or a propane set for natural gas. When using propane (LPG) gas an automatic pilot system must be installed.

There are many different local codes for gas fire logs. The installation of this set must conform to local codes or, in the absence of local codes, with National Fuel Gas Code ANSIZ223.1-1984
When glass fireplace doors are used always operate gas log set with the doors fully open to allow for proper combustion air.
A fire screen must be in place when the log set is in use.
The appliance and it's individual shut off valve must be disconnected from the gas supply piping system at test pressures in excess of 1/2 psig. The appliance must be isolated from the gas supply piping system by closing it's individual manual shut off valve during any pressure testing of gas supply system at test pressures equal to or less than 1/2 psig.
After burning, the logs become fragile and should not be handled. Knocking or rubbing logs can cause concrete to crumble and is not covered under the warranty.
Use a soft, dry paintbrush for periodic dusting of the gas fire logs. Special care must be taken to clean the Birch Logs. Rubbing will remove soot but will also remove the white pigments.
Do Not Burn Wood With This Set

Note: Adequate fireplace ventilation or draft is required for safety. Gas logs must be installed by personnel qualified for installing gas appliances. Read instructions fully before installing or operating.

For customer service or sales please email us at customerservice@americanchimneysweeps.com or sales@americanchimneysweeps.com